Golden Eagle Log Homes Blog

Here are some reasons why builders like Golden Eagle Log Homes. The plans are fully detailed so builders know exactly how the homes go together and what materials go where. But the main reason is the technical support; the people answering the questions and overseeing the plans have many years experience. Bob, a builder for over 35 years. Jim, a builder for 30 years. Glenn, a builder for 25 years and Andy, a builder for 10 years. Between them, there is not a question they haven’t heard or a problem they can’t solve. This is what makes Golden Eagle Log Homes special.

Yes, we always say if the builder is willing to learn, we can teach them how to build our homes. Our log homes are easy to build, unlike a handcrafted log home which is very difficult. Click here to see our training center.

Yes, any area where we have dealers we have builders. In the areas where we don’t have dealers, we know log home builders who will travel. We will also train new builders in your area. See the training center by clicking here

We can arrange for a builder to come to your job site and assist you with any problems that may occur. There is a substantial fee charged for doing this. We do offer a six day per week builder hotline that can assist you with any problems that may arise during the construction of your log home.

Log Preparation Procedures

Newly milled lumber often has a smooth, glossy surface from the planing process. This glossy surface can prevent the absorption of the finish and result in poor adhesion. Proper preparation as described below will help provide a porous surface that will adequately absorb the desired finish.

1. Wood should be dry-brushed using a brush with stiff bristles to remove loose dirt and fibers before preparation procedure.
2. Spray the surface with clean water to wet the wood.
3. Clean the surface with a solution of 1 quart of liquid bleach in 3 quarts of water. Apply this solution to the wood with a garden pump sprayer. Work from the bottom to top.
4. Let the solution sit on the wood for 15-20 minutes. During this period, scrub the surface with a hard bristle brush to help remove mill glaze. Do not let the solution dry on the wood. Keep it wet.
5. Power wash the cleaning solution from the wood with clean water using a power washer. To prevent damaging the wood, do not exceed 500 psi. The washer nozzle must be a maximum of 1 foot from the surface for full effectiveness. Rinse from the top down.
6. Sand all glossy patches with 80-120 grit sand paper.

Note: The wood must be completely dried out before staining.
On a full log home, the split log on gable ends, dormers and rim must weather for a period of time to blend with full log.

Coverage: 1st coat covers approx. 325 sq. ft., 2nd coat covers approx 425 sq. ft. (averages 375 sq. ft. /gal). Coverage for brushing & spraying is the same; however, you will need to add approx. 10% of mineral spirits when spraying to keep the nozzle from clogging.

SIKKENS APPLICATIONS

1. After proper drying, stain logs with first coat of Cetol log and siding.
2. Let dry 48 hours and caulk.
3. Apply second coat of Cetol log and siding.
4. Clean tools with paint thinner or mineral spirits.
   Like this article? Share it:

   • 
   • 
   • 
   • 
   • 
   • 
   • 
   • 
   • 
   • 
   •